Make sure TX-6 has MIDI CTRL IN enabled, and BLE set to ACCEPT.
MIX
- Select track (T1-T6) from top
- Slider controls volume
- Knob 1 controls filter and EQ
- Knob 2 controls compression, panning, and FX1 send
- Master knob controls master volume
- Selecting aux, cue, or master from the left to change what the volume controls affect. Note that
CUE has no effect for the slider
FX
- Switch between FX I/II, select engine, adjust parameters
- Enable with the large button
When FX1 is selected, select track from top row, then move the slider to adjust FX send for that
track.
When FX2 is selected, choose track from the Track dropdown. The selected track from the top row is
ignored.
Synth
- Set sequence, waveform, frequency, and length
- Use tiny keyboard for live playing. Set synth mode on TX-6 to either PLAY or SEQ/PLAY
- The last-pressed note will set the FREQ (used for sequences)
- Use the arrows to set the octave
LFO
Note: these only work while play is pressed. If you are sending CLK signal from the TX-6 this will
happen automatically. Otherwise set clock source to USB or BLE to control the BPM from the app.
- Configure LFOs with waveform, rate, amount, phase
- Control BPM and transport (play/stop)